Power Switch

Introduction.

This device gives you the ability to perform remote control from anywhere,
just point your serial connection or telnet connection.
This power switch can reboot Servers, Routers, and other devices.

• Then outlet 230VAC (European model).
• RS232.
• IP address, 10Base-T interface.
• Serial communication : 1 x RS232
• Network communication: 1 x RJ45 password protected.
• AC Input: 230 VAC 50 Hz 16 A Max.
• Current/outlet: 5 A MAX / outlet.
• Connector : DB9 DTE + 1 x DB25 + 1 x RJ45
• Operating Temperature : 0°C – 50 °C

Protocol
RS232 : Baud rate : 9600, N, 8, 1
command :
syntax: CPxy<CR>

C: start character
P: command
x: switch number: [0 1 2 3 4 5 6 7 8 9 A; F for ALL]
y: state: [0 = OFF, 1= ON, 2 or R = Reboot]
<CR>

Example:
CP01: power up de first plug (near power switch)
CP50: switch off the plug number 5
CPF2: Reboot (power off then power on) all the plug.

Each power plug have a status LED:
on: the plug is powered
off: the plug is not powered
blinking: the plug is in reboot state